▲Conventional steps:

Step one: After turning on the power, and the displayer entering into the main interface, touch the ’zero’ button, the weigher will clear out all the weigh hoppers, the sensor zeroing.

Step two: Turn on the conveyor to feed the combination weigher, pay attention to control materials according to material characteristics (conveyor should not be too much traffic).

The third step: According to the requirements to set parameters (speed, target weight,

each delay time, sample stable time, sample filter and other auxiliary parameters,

etc.).

Step four: Enter the manual testing menu to view the zeroing situation of the digital sensor, should avoid the interference of external factors (such as: man-shaking on the platform, fans and other environmental interference), to ensure a reliable sensor zero and then enter the Run interface.

Step five: According to the running condition, by adjusting the height of upper storage funnel to control the thickness of material, adjust vibrator amplitude and vibrator feed time, the delay time of each component, motor model, hopper open time, dump signal delay and other auxiliary parameters.

Step Six: Carry out effective verification, at the same time, adjust some parameters to achieve the accuracy and speed optimization according to the circumstances.

Step seven: After finishing packing, empty the little remaining material on the equipment. You can enter the main interface and touch ’empty’ button, and then the device will run automatically to clear the material.

Step eight: After emptying the material, close facilities, and then power off.

Step nine: cleaning equipment, make the cleaning cycle according to the nature of packaging materials. Usually if the packaged material is exposed, you need to clean once or twice a day, if there is over wrap, it can be cleaning once a week or every two weeks according to situation.

▲ Note during the using process:

◆It is prohibited to dismantle the displayer during running, since it may lead to

display interface is not corresponding with motherboard when connecting displayer

next time (equipment is still in power state), eventually result in displayer can not

work. If frequently, it will damage some spare parts of displayer.

◆It is not allowed to touch the weigh hopper or weigh driver unit when running, since it may result in weighing inaccuracy.

◆Non-staff is not allowed to adjust the material on linear vibrator pan, since it may

result in effecting feeding condition and even running effectiveness.

◆Relevant personnel are not allowed to shake randomly on the platform, since it may result in weighing inaccuracy.
                                                                       download this file